Giluform extra white

Special advantages

• Simple processing
• Quick solidification without additives
• Porcelain-like structure of the cast material
• No drying, no firing
• Accurate reproduction, also of finest details
• Surface-treatment possible with all commercial colours
• Not harmful to skin or injurious to health.

Recommendations for use

The casting form, for example a flexible plastic mould, is to be set up in a level position.

Next strew the plaster in the above mentioned ratio into the water, allow to soak, stir for approx. 1 min., taking care not to cause air bubbles.

In order to mix larger quantities it is advisable to use a mixing machine.

Pour the easy flowing mix in a thin stream into the middle of the form until the surface of the form is covered with a bubble free layer. The rest of the mix can be poured more rapidly.

Approximately 20 min. after casting the relief or model can be removed from the mould. Place the casting, which is becoming warm. Onto wooden lathes until it is completely cooled.

After allowing the casting to completely set, which takes about 8 hours, the surface may be treated in any desired manner, e.g. with dispersion or opaque colours.